Operating instructions

11
INSTALLATION
Using the remote control
Insert the AAA batteries included in the packaging
into the battery opening on the back of the remote
control. Make sure that the polarities (+ and -) are
aligned correctly.
The remote control operating range (approxi-
mate)
Note that the remote control’s power button only
works if the Main power switch on the rear of the
receiver is in the ON position and the LED on the
front of the panel is red. Weak batteries will affect
the performance range of the remote control.
Connecting the FM indoor antenna
Connect the FM indoor antenna plug to the output on
the rear panel.
Locate the other end where the reception is good.
It is also possible to connect communal antenna or
other external antenna.
Connecting the AM antenna
Connect the AM antenna wires according to the figure
below.
Place the ring as far from the unit, TV, and power cables
as possible. Adjust the placement of the ring for the
best possible reception.
Connecting an external audio source
Connect up to three external audio sources with RCA
plugs to AUX1/2/3 on the rear panel or with a 3.5 mm
[1/8 inch] plug to LINE IN on the side panel. Select the
respective audio source with SOURCE on the front
panel or on the remote control.
AUX IN on the rear panel LINE IN on the side
Operating range
up to 8 meter