User manual

English
7
iPod Mode (iPod/iPhone not detected via USB dock connector):
Using your iW1
Power ON modes
Note: The AirPlay Wireless button will continuously flash on/off to indicate that the iW1 is not linked to a network when ON and in
AirPlay Wireless mode.
100%50%vol. = 0%
iPod Mode (iPod/iPhone detected via USB dock connector):
AirPlay Wireless Mode (connected to a Wi-Fi network):
AirPlay Wireless Mode (not connected to a Wi-Fi network):
Volume
Press a specific volume level or slide your finger to the preferred volume level when changing the IW1 speaker’s volume on the unit.
Standby mode
Standby Mode (master power switch is ON):
Press the Power button to place the iW1 speaker in standby mode and stop audio playback. The Power button will pulse on/off to indicate
the unit is in standby mode.
The iW1 speaker has a backlit capacitance touch panel control interface for power, mode, volume, and music controls. Controls will be lit
according to the status of the iW1 speaker and the selected mode.
Note: Moisture and wet hands will cause issues with the ability of the iW1 to detect user interactions. Music transport controls will flash once
to signal a proper press.
Capacitance top panel controls
TOP PANEL
Volume / Battery level
iPod and iTunes
music controls
Power
AirPlay wireless mode
(audio via iOS device or iTunes)
iPod mode
(audio via USB sync cable or aux-in)