Specifications

OPERATION
Once all the connections are completed and checked, ensure that the volume control
on your preamplifier / integrated amplifier is at the minimum setting.
Ensure that the CD Transport connected to the DAC5 Special is switched ON.
Source components should always be the FIRST components to be switched on and
the LAST components to be switched off.
Ensure that all pre and power amplifiers connected to the DAC5 Special are
switched OFF.
The above procedure minimizes the possibility of loud noises produced by
components at switch on being passed to the loudspeakers and possibly causing
damage.
Turn on the DAC5 Special by using the rocker switch located on the rear panel,
above the mains inlet IEC socket. The red ʻpower onʼ indicator LED located on the
front panel should now be illuminated.
Turn on your pre amplifier / power amplifier / integrated amplifier. If you are using a
pre / power combination, always turn on the pre amplifier BEFORE the power
amplifier(s).
The DAC5 Special is now ready for operation!
Bedding in The DAC5 Special requires around 200 hours of initial use
(called “bedding in”) before the circuitry becomes stable and
optimum performance is realized. As the device “beds in” the
sound will become increasingly more smooth, detailed and
open. A warm up time of approximately 30 minutes is required
each time the device is switched on before optimum sonic
performance is reached.
Cleaning No special maintenance is required for the DAC5 Special. Use
a soft, clean lint free cloth to remove any surface marks from
the casework. For finger marks / grease, use a soft, clean lint
free cloth, lightly moistened with a solution of warm water and
mild detergent. Do not use any alcohol or solvent based
cleaning products, as they may damage the finish.
ENSURE THAT THE DEVICE IS SWITCHED OFF AND
DISCONNECTED FROM THE MAINS ELECTRICITY
SUPPLY BEFORE UNDERTAKING ANY CLEANING.
Valve Life The valves supplied with your DAC5 Special should provide
approximately 5 years of operation. They are specially selected
by us, and should only be replaced with valves of the same
type and specification. Please consult your Audio Note (UK)
dealer should your valves need replacing. Alternatively, feel
free to contact us directly.