Owner`s manual

UNPACKING & SET-UP

1. UNPACKING AND ACCESORIES:

The Classé CDT-1 has been carefully wrapped in heavy gauge plastic, packed in semi-rigid

foam and contained in a special box. To remove the unit, open and spread the top flaps of the box. By

its sides, lift the CDT-1 out along with its attached foam packing. Remove each foam side by pulling

them straight out. Remove the plastic wrap and inspect the unit for any concealed damage. Report any

concealed damage to your dealer promptly.

Apart from this owner's manual, please ensure the following is also included:

1) Detachable A.C. power cord.

2) Remote control handset (along with allen key and two (2) type "AAA" batteries).

Please report any missing parts to your dealer promptly.

2. SETUP:

The CDT-1 transport must be operated on a horizontal platform (see specifications for details)

such as a table or, preferably, specialized audio furniture to extract the best performance. Like fine

turntables and interconnect cables, the final location of the CDT-1 should be free of any hum-inducing

magnetic fields, such as those caused by power amplifiers, AC line filters and other regulation devices.

Such locations can introduce noise into an audio system, which inevitably degrades sound quality.

Ideally, a few feet should separate the CDT-1 from the power amplifier. As well, keep low-level

interconnect cables away from the power amp and separate from A.C. power cords.

The CDT-1 generates negligible amounts of heat. Therefore, air space around the CDT-1 for ventilation

need not be a concern.

Important! Check the Serial Number sticker on the back of the unit for the correct operating voltage.

Regardless of the voltage, the fuse rating should be a 3/8 AMP SLO-BLO type.