CDT - Two CD TRANSPORT OWNER’S INFORMATION
! IMPORTANT SAFETY INFORMATION ! HUMIDITY: DO NOT STORE OR OPERATE THIS UNIT IN AREAS OF HIGH HUMIDITY, OR IN CLOSE PROXIMITY TO WATER/DAMPINESS. DO NOT EXPOSE THE UNIT TO LIQUID. EARTHING: THIS PRODUCT MUST BE EARTHED – ENSURE THAT THE MAINS SUPPLY CABLE IS EARTHED. SHOCK: INTERNAL OPERATING VOLTAGES ARE LETHAL! DO NOT REMOVE THE TOP COVER. DO NOT ATTEMPT TO REPLACE THE FUSE WITHOUT DISCONNECTING THE UNIT FROM THE MAINS SUPPLY.
CLASS 1 LASER PRODUCT This product contains a low power laser device. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. Refer servicing to qualified personnel. Make Your Contribution to Protect the Environment Used batteries with the ISO symbol for recycling, as well as small accumulators (rechargeable batteries), mini-batteries (cells) and starter batteries should not be thrown into the dustbin. Please leave them at an appropriate depot.
GENERAL Congratulations on your purchase of the Audio Note CDT Two CD Transport. Audio Note is highly critical of the digital medium as presented by compact disc; we sincerely hope that you too will find this transport breaks free from the 'digital mould' that we are all so accustomed to, and so open a new window on your CD collection. Please read over this manual carefully in order to obtain the best possible performance and longevity from your transport.
OPERATIONS VIA BUTTONS LOCATED ON THE FRONT PANEL PLAY/PAUSE Press this button to play a disc. Pressing this button again will pause playback. Press the button again to resume playback. STOP Press this button to stop playback. SKIP ( 9 DISPLAY : ) Press these buttons to go to the previous or the next track. Press this button to change the intensity of display or to turn it on/off.
PROGRAMMING You may select a number of tracks and store them in the memory in the desired sequence. The transport will then play back only your selection of tracks in the selected order. 1 2 3 4 5 6 Press the MEMORY button. 'MEMORY' will appear on the display. Press the CD SKIP or numbered buttons - To select the desired track to be stored. Press the MEMORY button - The track is now stored in the memory. Repeat steps 2 and 3 to complete programming. Press PLAY to listen to the programmed tracks.
TROUBLESHOOTING GUIDE Refer to the relevant sections in the manual for remedy suggestions. SYMPTOM No sound from the CD player. CHECK POINT CD is not selected on the amplifier. Playback does not start. The disc cover is not fully closed. The disc is dirty. The disc is upside down. The player is in the PAUSE mode. Moisture condensation has caused the unit to operate incorrectly. " NO DISC" appears. There is no disc loaded or the disc is loaded incorrectly. Playback does not start from the first track.
