Owner`s manual

Note: For best results, do not burn-in the CD-1 continuously for more than 6 to

8 hours. Give the unit a break before you turn it on again. Burn-in the CD-1

without any stress and be sure to use the system, “Normally”.

During the break-in period, the sonic properties of your electronics may

undergo several gradual shifts as the various components break–in at

different rates. It is therefore suggested that the fine tuning of the system be

delayed until after the break–in period is completed. However, during the

final phases of the break–in period, the sonic image will open up, the sound

stage will bloom to perfection, the bass control and impact will increase and

the overall sound will have a more involving soundstage presentation.

OPERATION

Turn on the power switch at rear panel, insert a CD, label side up and affix

the CD with the magnetic puck. The “ayon” logo will light up, followed by the

“Warm Up” message on the front display panel. Then the total track number

and playback time will be indicated on the front display panel.

HOW TO PLAY A CD - IMPORTANT

Playing a CD

1) Press the OPEN/STOP button – “Open” lights up on the front display panel.

2) Carefully, place the CD on the CD Spindle and place the Magnetic Puck

on the “Spindle”, the top center of the CD.

Note: Never play a CD without magnetic puck affixed to the CD.

3) Press the OPEN/STOP button AGAIN – This action requests a read of the CD.

4) The total track number and playback time for the entire disc is shown on

the front display panel.

5) Press Play to activate playback from the beginning of the CD.

6) To STOP the CD, press the OPEN/STOP button.

PLEASE NOTE:

7) Each time a CD is changed, you must press the OPEN/STOP button twice,

requesting a read of the new CD!