User's Manual

- 14 -
A10-RX User Guide
Mic2Wav supports the creation of up to eight user groups, each with a max of 32 users, per
Audio Limited User Group (ALUG) le.
To add additional user groups:
1. In Mic2Wav, select Add Group.
2. Name the new group and select the band of frequencies for the group.
3. Add users (dening name and frequencies) to the group.
Audio Limited User Group les (ALUG) may be saved for future use and modication. When
saving the ALUG le, Mic2Wav will default the le name to the rst User Group name in the
drop-down list.
To load an ALUG le into Mic2Wav:
1. In Mic2Wav, select User Group File > Open.
2. Choose an ALUG le on your computer.
To remove a user group:
1. In Mic2Wav, select a User Group in the drop-down list.
2. Select Remove Group.
Sending and Loading User Groups onto A10 Receivers
While each ALUG le may contain up to eight user groups, only one group at a time may be
sent to and loaded on an A10 receiver. A user group is sent to the A10-RX-XLR by directly
connecting it to a computer via USB. Sending a user group to the A10-RX-SL is achieved via the
A10-RACK or the Sound Devices 688 with attached SL-6.
ª For instructions on sending user groups to A10 transmitters, see the A10-TX User Guide or
the A10-TX-US User Guide.
To send a user group to an A10-RX-XLR:
1. Start the Mic2Wav application.
2. Connect the receiver (micro USB) to the computer’s USB port.