Specifications

Audio International, Inc. A/V-9691-01(-02)-x Installation & Operation Manual
Document # 540250, Rev D, 07/2004
Page 12 of 33
3.3 Cautions and Warnings
3.3.1 It is important to do a pin-to-pin power and ground check on all
connectors. Ensure that power and ground are applied only where
specified. Damage to the unit may result if power or ground is
applied to the wrong points.
3.3.2 Perform a pin-to-pin check to confirm that the wiring terminates in
the proper location. Ensure that there is only power and ground
where required.
3.3.3 DO NOT remove any factory-installed screws. Damage to the unit
may result and void any warranties.
3.3.4 DO NOT install near heat sources such as direct sunlight, warm air
exhausts, or heaters.
3.3.5 DO NOT connect or disconnect the distribution unit with power
applied.
3.3.6 Allow adequate air circulation (1-inch square on all sides, minimum)
to prevent the build-up of internal heat.
3.3.7 DO NOT drop or subject unit to heavy impact.
3.3.8 No periodic scheduled maintenance or calibration is required for
continued airworthiness of the A/V-9691-01(-02)-x Audio/Video
Distribution Cabin Amplifier. If the unit fails to perform to
specifications, it must be removed and serviced by a qualified
service facility.
3.3.9 ESD (Electro Static Discharge) guidelines shall be followed.