User Guide

10
SPECIFICATIONS
MODEL- PRIME R250-1 R500-1 R1000-1d
Contin
uous Power Rating (RMS) - Measured at 14.4 Battery Volts*
4Ω Load Mono 150 Watts x 1 320 Watts x 1 500 Watts x 1
2Ω Load Mono 250 Watts x 1 500 Watts x 1 1000 Watts x 1
Dimensions: Height 2.40" (6.10cm) 2.40" (6.10cm) 2.40" (6.10cm)
Width
7.67" (19.49cm) 7.67" (19.49cm) 7.67" (19.49cm)
Length
11.54" (29.30cm) 16.65" (42.30cm) 11.54" (29.30cm)
Amplifier Fuse Rating (Amp)
(1) 30A ATC (2) 30A ATC (3) 30A ATC
Batter
y Fuse Rating (Amp) External (Not Supplied) 40A 60A 90A
“A” Weighted Signal to Noise Ratio (CEA-2006)
Referenced to 1 Watt into 4 ohms ≥80 dB
“A” Weighted Signal to Noise Ratio
Referenced to rated power into 4 ohms ≥100 dB
Crossover Slope 12dB/octave Butterworth
Crossover Frequency Low Pass variable from 40Hz to 130Hz
Frequency Response 20Hz to 130Hz ±1dB
Signal Voltage Adjustment Range Variable from 150mV to 8V (RCA Input)
Remote Punch Level Control (replacement kit) #PLC
Protection Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Punch Bass Variable from 0dB to +12dB @ 45Hz
Input Impedance 20K ohms
Operating Voltage 9 to 16 Volts DC
Balanced Inputs No
Damping Factor >200
THD+N (Total Harmonic Distortion + Noise) < 1.0% @ 4 ohm
Specifications subject to change without notice
* These specifications are CEA-2006 Compliant