User Guide

MERCURY I|ENG

INTERCONNECTION MASTER

• Connect the RCA lineouts of the headunit with the RCA jacks LINE IN of the amplifier with appropriate high-value RCA cables.

If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.

• Connect the remote wire (REM) to the remote terminal (REM) of the MASTER amp.

• Connect the bass level controller only on the BASS LEVEL CONTROLLER port of the MASTER amp.

INTERCONNECTION SLAVE

• Connect the RCA jack MASTER OUT of the MASTER amp with the RCA jack SLAVE IN of the SLAVE amp with appropriate

high-value RCA cable.

• Connect the remote wire (REM) of the remote terminal (REM) of the MASTER amp with the remote terminal (REM) of the SLAVE amp.

Use therefore cable with a minimum profile section of 0,5 mm

INTERCONNECTION SUBWOOFER

• See page 20.

SETTINGS MASTER

• The MODE switch should be in MASTER position.

Check the information of LPF, SUB SONIC, PHASE, LEVEL, BOOST and BASS LEVEL CONTROLLER on page 18.

SETTINGS SLAVE

• The MODE switch must be in SLAVE position.

In the SLAVE mode all controllers of the SLAVE amp are without function.

Only the already modified audiosignal of the MASTER amp will be amplified.

INTERCONNECTION EXAMPLE Master/Slave Mode

1. Connect Stereo RCA output (L/R

or SUB OUT) of the headunit with the

LINE IN CH1/2 of the MASTER amp

Connect the bass level

controller and the remote terminal

on the amplifier (MASTER)

with the enclosed cable.

Switch setting: MASTER

SLAVE

MASTER

Switch setting: SLAVE

Remote wire REM

2. Connect the RCA output (MASTER

OUT) of the MASTER amp with the SLAVE

IN of the SLAVE amp