SALES NOTE

Key Features of the
™Matrix Plus™
Balanced Differential Inputs:
The Matrix Plus will accept up to
six channels of input signal which
means it will work with source units
that have six channels of output
or it will accommodate three two-
channel source units as in the case
of multi-media. All of the inputs
utilize a balanced differential input
circuit, which can cancel noise that
radiates into the signal path.
Power Connector: This convenient
little connector allows you to hook
up all the power and turn-on wires
for your Matrix Plus Line Driver in
the convenience of a well-lighted
area and then plug them in by feel
all at once in your trunk’s cavernous
darkness.
Level Control: The MATRIX Plus provides up
to 24dB of signal gain or 12 dB of signal
attenuation (cut). This allows you to raise a
pre-amp signal as high as 13 volts peak output
or reduce it as required to match the levels of
multiple sources.
Remote Level Control Input: Input for
optional ACR-1 dash mountable remote
level control.
Input Linking: There is amazing flexibility with the Matrix
Plus for routing one input to one, two, or three outputs.
These “Connected to Main” LEDs light when the jumpers
under the cover are set to route the main input to
outputs “Channel 2” and/or “Channel 3”.
Voltage Indicator LEDs: These lights will tell you when
the signal level is at 1 volt, 2 volts or 5 volts. You’ll most
likely want at least the 2-volt light to flicker, more if the
rest of your components can handle it. Any AudioControl
component that you connect after the Matrix Plus Line
Driver won’t mind the 5 volt light flickering. Go ahead.
Light it up!
Outputs: The Matrix Plus has six
channels of low impedance output,
which means each pair of outputs
on your Matrix Plus has the strength
and ability to drive more than just one
amplifier. In fact, you can drive up to 7
amplifiers off of each pair of outputs,
which means you have the possibility of
driving 21 stereo amplifiers or even 42
mono amplifiers! Wow!