USER MANUAL
page 6
7. Power: If you have connected all of your power wires correctly,
this light should be bright red when your system turns on.
8. Remote Source/Level Control:
This multi-function dash control
allows you to select the input source and set the level of the subwoofer. It
also controls the auxiliary input volume. “Source” and “Level” LEDs let
you know the status of the controls. See Figure 9: Dash control LEDs for
an explanation of LED functions.
9. Pre-Amp Outputs: These are the RCA plugs on the output side
and should be connected to the next component after the LC8i, such as
a signal processor, crossover or amplier. Do not connect any speakers
directly to your LC8i. (Denitely don’t connect to any home appliances,
like your microwave.)
10. Level Controls: These knobs allow you to adjust the signal level
from your source unit to match that of your after-market ampliers. Be-
cause they are amplied, most factory-installed source units have rela-
tively high signal voltage output, which will require you to decrease the
signal level. There is also an Auxiliary input level control to allow you to
balance the auxiliary input with the main input.
Figure 2: LC8i Top View
®
¯°±
´
¬
②
²
µ
³