USER MANUAL
page 15
System Hiss: Check to make sure that your amplier gains are set at
the minimum level. Possibly revisit “Level Match” instructions on page
10.
Turn-On Pop or Turn-Off Pop: This generally occurs when your am-
pliers are turning-on or off at a different time than your LC8i . There-
fore it is recommended that you use the “Remote Out” on your LC8i to
turn your ampliers on or off and eliminate any timing issues
Low Output: Depending on the design of your factory-installed
system, you may actually be connecting to a pre-amp signal instead of a
speaker-level signal. Since the LC8i is a line output converter you may
need to turn up the gains on the LC8i or consider adding a pre-amp line
driver like the AudioControl Matrix to increase the signal level to your
aftermarket ampliers.
Maximized LED Does Not Light Up: If your system is playing music
but the Maximized LED is not coming on, there is a good chance that
the output voltage of your source unit is not that high. Try increasing the
input level controls on the top of your LC8i .