USER MANUAL
----------------------------------------------- 5 -----------------------------------------------
Internal Channel Summing
The LC6i has the unique ability to internally sum together mulple (4 or
6) input channels from the factory source unit into 2 channels. This is
parcularly handy when using the LC6i with a factory system that has
mulple, acvely crossed-over signals being sent from the OEM source
unit or amplier(s). For example, in some vehicles there is an acvely
crossed-over tweeter, midrange, and woofer all in the front of the vehi-
cle. The LC6i lets you take all of those signals and sum them together
to get a high-quality, full-range, pre-amp signal without the use of any
addional cables or hardware. Internal jumpers allow you to sum the
channels 2 and 3 to the main outputs, or keep them separate.
AutoMode Inputs
Somemes in life (and car audio) we need more outputs than inputs.
Therefore we have equipped your LC6i with AutoMode inputs that
take the Channel 2 signal and automacally feeds it to the Channel 3
outputs, provided there is no signal present on the Channel 3 inputs.
This means your LC6i will accept two input channels and give you four
output channels. Or it can accept four input channels and give you
six output channels. The AutoMode can be disabled by moving an
internal jumper.
Output Level Controls
Your LC6i has level controls for each pair of channels. These controls
allow you to adjust the signal level from your factory-installed amplier
or source unit to match up with your aermarket amplier or proces-
sor.