USER MANUAL

-----------------------------------------------20 ----------------------------------------------
Speaker-Level Inputs
The LC6i is designed to accept an amplied, speaker-level signal from
a factory source unit or amplier. You will want to refer to a facto-
ry service manual or wiring-harness schemac to determine which
wires are the speaker wires for your system. If you are unsure which
wires are the speaker wires, it is recommended you look at the color
of the speaker wire connected to the speakers and follow them back
to the factory source or amplier. Connect the speaker wires to the
Speaker-Level Inputs on your LC6i. Make sure to get your “pluses” and
“minuses” connected properly.
Pre-Amp Outputs
Connect good quality RCA connectors from these outputs to the inputs
of your ampliers. While we won’t get into the discussion as to wheth-
er plutonium cables sound beer than un-obtainium cables we will
tell you that well-constructed cables are less problemac in a rugged
environment like your car system.