USER MANUAL

-----------------------------------------------15 ----------------------------------------------
Installing Your LC6i
By this me we are sure that you are chomping at the bit to install your
LC6i. Up to this point, everything you have read has served to educate
you on the operaons of LC6i. Therefore if you are sll with us, we
recommend you read the following secons very carefully.
Placement and Mounting of the LC6i
Your LC6i can be physically installed in numerous locaons like behind
your dashboard, under a seat, or even in the trunk/boot. Since you will
be connecng to the speaker wires from the factory source unit or its
amplier(s), you should select a locaon that is convenient for wiring.
Once you have selected a permanent mounng locaon, posion the
unit and mark the appropriate mounng holes with a felt-p pin or
scratch awl.
Before doing anything else, make sure you are not about to drill
a hole in a gas tank or pierce any exisng wiring, fuel lines, or
hydraulic pipes. Nothing ruins your day more than an expensive
repair bill or massive reball.
Drill a few small pilot holes and secure the chassis of the LC6i with
self-tapping screws.