Specifications

page 10
SETTING THE CROSSOVER MODULES
Selecting the Crossover Frequencies: Your 6XS comes
“preloaded” with crossover modules that will allow it to work in a
number of system configurations. Here are the factory settings:
Should your system require different frequencies than what comes
with the 6XS, fear not, as you can change the crossover modules to
accommodate just about any system configuration.
Most importantly, we recommend that you select crossover
frequencies according to the characteristics of your speakers. We
suggest the following ranges:
Tweeters: 3500 Hz and higher
Midrange: 250 Hz to 3500 Hz
Midbass: 80 Hz to 250 Hz
Subwoofers: 150 Hz and lower
As there is probably a good chance that you are not using Audio-
Control speakers (because we don’t make speakers), we suggest
you contact the manufacturers of your speakers for their recom-
mendation.
The Legacy Of Crossover Modules To change the crossover
frequency on your 6XS, AudioControl products use a nifty plug-in
module. Crossover modules are more accurate and reliable than
most knobs or simple switches that are offered by other manufac-
tures and come on many amplifiers. Your authorized AudioControl
dealer will generally stock a wide selection of crossover modules
for your 6XS should you wish to change the crossover frequencies.
Four/Six Two
Outputs Channel Input Channel Input
Front Highpass 250 Hz and up 250Hz and up
Front Lowpass 90 Hz to 250Hz 90 Hz to 250 Hz
Rear Highpass 250 Hz and up
Subwoofer 30 Hz to 90 Hz 30 Hz to 90Hz