Install guide
page 14
7 At his point you can adjust your amplier gain control according to
the specications of your amplier manufacturer.
Parallel Outputs
The DQDX is equipped with AudioControl’s unique Front to Sub
circuit input that allows for the Front input signal to feed the Subwoofer
outputs, when you do not have a Subwoofer input signal available. This
allows your DQDX to accept front and rear inputs channels and give you
Front, Rear, and Subwoofer output channels. Refer to the Under The
Cover section to learn more on jumper selection.
Remote Level Control - ACR-3
The ACR-3 is a multi-function remote that used for making the initial
signal delay adjustments in the Set-Up mode and then providing level
control over the Subwoofer output in the Normal mode. This allows you
to balance the bass level with the rest of the system and then increase or
decrease as needed. An additional feature of the ACR-3 dash remote is
that it allows the signal processing of the DQDX (equalization and signal
delay) to be switched in and out of the audio circuit. That means that you
can hear the system with and without the processing to hear the differ-
ence that the tuning makes in the sound of your system.
Dash Control Placement And Mounting
The ACR-3 dash control may be mounted under the dash using its own
bracket or through a custom hole in the dash. It should be
within reach of the driver and in a spot where the LED is
plainly visible.
Bracket Installation
The dash control mounts with two
screws, which attach to the un-
derside of the dashboard. Slide
under the dash and place the
dash control in its mount-
ing position, mark the two
mounting holes, drill pilot holes, and secure with two screws.
Custom Installation
For that custom, nished look, the dash control can be ush mounted
directly on the dash-board (or anywhere else). Referencing the gure
above, disassemble the dash control from the mounting bracket. Start by
pushing the LED from its holder followed by removing the circuit board
Dash Control Assembly