USER MANUAL

36
Installation Manual
RTA (Output)
1. For stereo outputs, the RTA shown is the sum of the left and right
channels, so if you have two channels out of phase, very little will
show. If your left and right channels are not time-aligned, you will
see comb ltering.
2. The sensitivity control is labeled to match the classic AudioControl
SA-3050.
3. The speed control changes the settling rate (fast, medium, slow).
Note that the low frequencies always have a slower settling time
than the higher frequencies as they require longer to stabilize.
4. The output RTA shows the level of signal at the output of the DSP,
after time alignment, summing, AccuBASS® and EQ, but before
the output level and MUTE control. The practical value of this is
that you can tune the EQ in a car with the outputs MUTED and not
have to listen to pink noise.
Chapter 8: The Display: Output View