Specifications

MMZ 6020 MMZ 6000
AUDIO MATRIX
AUDIO MATRIX
20
6-in x 6-out matrix for the control
and amplification of 6 audio zones
• 4 stereo inputs with link to
connect another matrix (Tape,
Tuner, CD, Aux)
• 2 RS-485 connectors for the
connection of two paging
microphone consoles (MBT
6000)
• 1 XLR-F (Aux Mic) input allows
to connect a microphone input
or a MB-T 6400 S, BF-T5043L
console and can have priority
over the RS-485 Mic input;
moreover, 24V Phantom power is
available on this input
6-in x 6-out matrix for the control
and amplification of 6 audio zones
• Same features as the MM Z
6020 matrix, without the power
outputs necessary for driving the
loudspeakers
• 6 20Wrms ampliers, each
with 4ohm minimum output
impedance
• 6 RS-485 connectors (Zone
Remote Control) for the
connection of local remote
controls that, trough the
IR remote control, allow to
adjust: volume, high and low
tones, power on/off and music
programme selection (Tape, etc.)
• 1 2x16 character display allowing
to view the status of the 6 audio
zones
482
88
MMZ 6020 MMZ 6000
Code 31081 31082
Maximum input level Gain min +10dBu (245V) -
Tape, Tuner, CD, Aux max -5dBu (435V)
Aux Mic 1 input max gain -70dB -70dB
Phantom power 24V 24V
Treble ±14dB a 12kHz ±14dB
Bass ±15dB a 12kHz ±15dB
Left, Right, Sub/mono output level +3dB +3dB
Frequency response (@ -3dB) 30Hz÷50kHz 30Hz÷50kHz
tHd-n (@ L. R, Sub/mono outputs) 0,013% 0,013%
SPKR output power
(@ 1% THD+N 20Hz÷20kHz) 6x20Wrms -
Signal/Noise ratio 88dB typical -
Power supply mute -90dB min. -
SPKR output protection short circuit/thermal -
Power supply 230Vac 50/60Hz 230Vac 50/60Hz
Power consumption 220Va 30Va
Dimensions 2 U rack 2 U rack
TRC 6000
MBT 6000
Kit
Microphone console
Kit including a TX 6000 transmitter (IR remote
control) and a RX 6000 IR receiver
code 31085
•Themaximumoperationdistancebetweenthe
transmitter and the receiver is 20 m; no obstacles (unless
transparent)canbeplacedbetweenthetransmitterand
thereceiver•Thezonetransmitterallowstoadjust:
volume,highandlowtones,poweron/offandinput
selection (tape, tuner, etc.)
•Thereceiverisconnectedtothematrixthrougha
4-conductor telephone cable (max. length 500 m) ending
withtheRJ-45connector(PIN1,2,3,4)
Microphone console designed for
the MMZ 6000/6020 matrixes; it can be connected
to RS-485 interface
Code 31083
see page 36