User manual

6
7
1180R
1180T
A B
HDTV Source
HDTV
3.2 ROUGH-IN AND WIRING
The Cat 5 receiver is usually placed
in or on the wall or ceiling behind a
television display or near a projector
that is remotely located from the main
home entertainment system where the
transmitter is located. To assure service
access, it is recommended that a two-
gang plaster ring be provided for an
1180R receiver if mounted inside a wall.
Pull good quality Category 5e or 6
UTP cable from the driver location to
the receiver location. Be careful not to
pinch, kink, or tightly staple the cable. It
will be helpful to note the cable length of
the run because you will have to adjust
the cable length compensation when
installing the Cat 5 Receiver. Install an
RJ-45 plug on each end of the Cat 5
cables, using EIA-568 pairing (pins 1-2,
3-6, 4-5, 7-8). Check the cable with
a professional network cable tester
that verifies conductor pairs.
5 WHITE / BLUE 7 WHITE / BROWN 6 GREEN 3 WHITE / GREEN 2 ORANGE 4 BLUE 8 BROWN 1 WHITE / ORANGE 5 WHITE / BLUE 7 WHITE / BROWN 6 GREEN 3 WHITE / GREEN 2 ORANGE 4 BLUE 8 BROWN 1 WHITE / ORANGE
EIA-568B STANDARD TERMINATION
ADDITIONAL CAT 5 OUTPUT (OPTIONAL )
CAT 5 CABLE CARRIES A/V
SIGNALS PLUS RECEIVER
POWER UP TO 700 FT.
TRANSMITTER
POWER
(REQUIRED)
RECEIVER POWER
IS NOT REQUIRED
FOR DISTANCES
UNDER 700 FT.