User Manual HDTV Cat 5 Extender Video and Audio Over One Cat 5 Cable Model SCP-11 and SCP-11D Model 1180T Transmitter Model 1180TD Transmitter Model 1180R Receiver Model 1180RD Receiver
WARNINGS • Read these instructions before installing or using this product. • To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. • This product must be installed by qualified personnel. • Do not open the cover—there are no user-serviceable parts inside. • Do not expose this unit to excessive heat. • Install only in dry, indoor locations. • Clean the unit only with a dry or slightly dampened soft cloth.
Model SCP-11 and SCP-11D HDTV Cat 5 Extenders TABLE OF CONTENTS 1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . 4 2.0 Checking Package Contents . . . . . . . . . . . . . . . 4 3.0 Installation . . . . . . . . . . . . . . . . . . . . . . . . 5 4.0 Adapting Dual Cat 5 Systems Using Model 1110 . . . . 8 5.0 Getting the Best Results . . . . . . . . . . . . . . . . . 9 6.0 Troubleshooting . . . . . . . . . . . . . . . . . . . . . 9 7.0 Limited Warranty . . . . . . . . . . . . . . . .
1.0 INTRODUCTION Thank you for purchasing this HDTV Cat 5 Extender from Audio Authority. The SCP-11 system incorporates the signal paths necessary for premium audio and video distribution over just one inexpensive, easy to install Cat 5e/6 cable. Each Cat 5 transmitter is capable of distributing HDTV signals to one or two receivers located up to 1,000 feet from the source. The Cat 5 receivers can be powered from the transmitter through the Cat 5 cable in most applications*.
3.0 INSTALLATION While the SCP-11 is ideal for new construction or an existing home, it does require special knowledge and tools to install. We suggest you contact a local custom home installation specialist. Many installation specialists are members of the Custom Electronic Design & Installation Association and can be located through the CEDIA website: www.cedia.org. 3.
1 2 3 4 5 6 7 8 Pull good quality Category 5e or 6 UTP cable from the driver location to the receiver location. Be careful not to pinch, kink, or tightly staple the cable. It will be helpful to note the cable length of the run because you will have to adjust the cable length compensation when installing the Cat 5 Receiver. Install an RJ-45 plug on each end of the Cat 5 cables, using EIA-568 pairing (pins 1-2, 3-6, 4-5, 7-8).
! WARNING: continuity testing is not adequate; the twisted pairs must be placed in precise order in the connector, or damage to the equipment may occur. 3.3 INSTALLING THE CAT 5 RECEIVER(S) • Plug the Cat 5 cables into the 1180R or 1180RD. • Adjust the cable length compensation if the cable between the transmitter and receiver is over 100 feet long. Set the compensation at 1 for cables 100-199 ft.. long, and 2 for 200-299 ft.. cables, etc.
3.4 INSTALLING THE CAT 5 TRANSMITTER • Mount the 1180T or 1180TD Transmitter and connect component video and audio cables from the source equipment to the inputs of the Transmitter. • Plug the Cat 5 cable into an output jack on the Transmitter (either or both may be used), and power up the A/V equipment connected at each end. • Power the SCP-11 system (install a receiver power supply if the Cat 5 cable is over 700 feet long).
Below is an example of an AVAtrix system with a Model 1180RD. The single Cat 5 receivers may be used in the same system with dual-Cat 5 receivers. AVATRIX CAT 5 HD MATRIX ALWAYS TEST PRE-FABRICATED CABLES FOR PROPER PAIRING! B OUT ! B A A SINGLE CAT 5 UP TO 700 FEET MODEL 1180RD MODEL 1110 DUAL-TOSINGLE CAT 5 ADAPTER 5.0 GETTING THE BEST RESULTS • Output display device. The quality of the output signal depends largely upon the type and quality of display device used.
7.0 LIMITED WARRANTY If any consumer product from Audio Authority fails due to defects in materials or workmanship within one year from the date of the original sale to the enduser, Audio Authority guarantees that we will replace the defective product at no cost. Freight charges for the replacement unit will be paid by Audio Authority (ground service only).
8.0 SPECIFICATIONS Video Signal Type Component (YPbPr) Video Resolutions/Formats 480i/p, 540i/p, 720p, 1080i/p Input/Output Impedance 75 ohms Input Ground Isolation Yes Gain 1 Gain Accuracy 3% 3dB Bandwidth 120MHz Input Coupling AC S/N Ratio 35dB Max Gain/Equalization 40dB equalization Audio Format Digital Digital Input/Output Type Coaxial Input Impedance 75 ohms Min Load Impedance 75 ohms Multi-channel Digital Yes Agency Approvals FCC DC Input Connector 5.5 X 2.
2048 Mercer Road, Lexington, Kentucky 40511-1071 Phone: 859-233-4599 • Fax: 859-233-4510 Customer Toll-Free USA & Canada: 800-322-8346 www.audioauthority.
