Install guide

This last step will recode the MFSW control unit to enable telephone and voice activation operation.

Select “16-Steering Wheel” on the Control

Module Screen

The software is now connected to the new

MFSW control unit in the “Open Controller”

window. Note the Software Coding located

just below the part number display. Check

the chart below to see what the coding means.

If the coding is satisfactory, exit out of the

VAG-COM software and skip the remainder

of this section. If the control module needs to

be recoded, continue with the steps below.

The last digit of the software coding is the only one to be

changed in this step. To enable radio and telephone

buttons only, a value of “1” should be used. To also

enable voice recognition, a value of “5” should be used.

Voice recognition allows the driver to press the

button to activate the mode. The driver can then speak

commands to redial, dial digits, or voice dial with saved

voice tags. See Appendix K for more information.