Install guide

© 2005, 2006 Lee H. NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1 Page 41
The next step is to code the RNS-E to recognize the Bluetooth Module data over CANbus.
The RNS-E unit must be running at least US firmware version 0110 for telephone
functions to be activated. This firmware is on the North America Version 2A DVD.
Select “37-Navigation” or “56-Radio” on the
Control Module Screen. Either option will
access the RNS-E for coding.
The software is now connected to the RNS-E
in the “Open Controller” window. Note the
Software Coding located just below the part
number display. Check the chart on the next
page to see what the coding means. If the
coding is satisfactory, exit out of the VAG-
COM software and skip the recoding
instructions. If the control module needs to
be recoded, continue with the steps below.
Control Module Coding Chart for RNS-E Navigation Unit
Only the 5
th
digit needs to be changed and a value of “6” must be used.
0xxx?xx: Telephone / Telematics
1 – No Telephone
2 – Telephone (Temic) Not used with US-Spec Bluetooth Module
3 – Telephone (Cullman ) Not used with US-Spec Bluetooth Module
4 - Telephone (Nokia ) Not used with US-Spec Bluetooth Module
5 – Telematic EU Not used with US-Spec Bluetooth Module
6 – Telematic US
7 - Mobile phone preparation self-diagnostic-able with comfort operation