Install guide

© 2005, 2006 Lee H. NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1 Page 40
To change the adaptation values, press
“Adaptation-10”
Scroll through each adaptation
channel that is listed in the chart
below. Enter the correct value
based on the vehicle
charateristics. When finished,
press “Done, Go Back”.
Exit back to the main VAG-COM
screen when finished.
No adaptation values were altered for my installation. My speaker and microphone volumes require no correction.
Control Module Adaptation Chart for Bluetooth Telephone Module
-> Channel 128 (Base Volume)
000 - 0dB (no increase/decrease)
001 - +1dB increase
003 - +3dB increase
006 - +6dB increase
128 - -1dB decrease
130 - -3dB decrease
133 - -6dB decrease
-> Channel 129 time after ignition off
000 - 30 Seconds
001 - 5 Minutes
002 - 10 Minutes
240 - 20 Hours
-> Channel 133 (BT)
BT activate/deactivate.
-> Channel 134 (handsfree)
0 - handsfree over BT
1 - handsfree only with mobile in cradle
-> Channel 131 (Microphone Sensitivity)
000 - 0dB (no increase/decrease)
001 - +1dB increase
002 - +2dB increase
003 - +3dB increase
004 - +4dB increase
005 - +5dB increase
006 - +6dB increase
128 - -1dB decrease
129 - -2dB decrease
130 - -3dB decrease
131 - -4dB decrease
132 - -5dB decrease
133 - -6dB decrease
-> Channel 135 (Bluetooth PIN)
default: 1234
(The Bluetooth PIN can be set within
the RNS-E menu system at any time.)