Install guide

© 2005, 2006 Lee H. NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1 Page 37
4.3 Control Module Coding (VAG-COM)
The BT module, RNS-E, instrument cluster, and MFSW must be coded to ensure proper operation.
Connect a diagnostic cable to the vehicle and start the VAG-COM software on the computer.
In leiu of using VAG-COM software, the vehicle can be coded at any Audi dealership. Expect to pay for this service.
VAG-COM Release 512 is recommended.
From the Main VAG-COM screen, press
“Select” under the Select Control Module area.
Select the “Electronics 1” tab at the top of the
list, then select “77-Telephone” on the Control
Module Screen.
The software is now connected to the TEL
module in the “Open Controller” window.
Note the Software Coding located just below
the part number display. Check the chart on
the next page to see what the coding means.
If the coding is satisfactory, exit out of the
VAG-COM software and skip the recoding
instructions directly to the adaptation
settings. If the control module needs to be
recoded, continue with the steps below.