Install guide

© 2005, 2006 Lee H. NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1 Page 36
The final step of this section is to splice the other end of the repair wire into the K-line. The K-line is
the small green wire that connects to pin 7 in the VAG diagnostic connector. In the picture below, a
small section of the wire tape was removed a few inches back from the connector end. The small green
wire was spliced using a red (18-22AWG) wire splice tap. Secure the repair wire by taping off to other
wiring harnesses or by using cable ties. Using fabric tape, wrap the section of the VAG connector
wiring harness that was just spliced to hide the work and protect the connection.
Reinstall the left side lower A-pillar trim and driver’s side knee panel.
The physical installation of the Bluetooth telephone module is complete.