Install guide

© 2005, 2006 Lee H. NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1 Page 35
Now the cover can be removed from
the bottom section to reveal and
unlock the wiring pins inside.
Pin 13 in this connector is a small grey wire to be replaced. Simply use a small screwdriver or knife
blade to disengage the locking tab on the grey wire and gently pull out from the rear. This will be very
similar to the wiring in section 1.1.1 of this document to remove the pins from the 32-pin instrument
cluster plug. Once the grey wire is removed from pin 13, tape the contact end off and tuck away into
the wiring harness. This pin will not be used and is not connected to anything, but there’s no reason
to cut it off completely.
Insert a new repair wire (000-979-009) into pin 13 of the connector T15s.
Re-assemble the blue wire housing plug by sliding the cover back on then sliding the top portion back
on with the three larger wire pins. Plug the connector back into its position in the connector station.
This wire is now connected to pin 12 in the DB25 connector in the trunk which connects to pin 15 at
the Bluetooth module through the custom harness assembled in the previous subsection.