Install guide

© 2005, 2006 Lee H. NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1 Page 27
3.2 Control Module Coding (VAG-COM)
The new MFSW control unit must be coded with VAG-COM to ensure proper operation.
From the Main VAG-COM screen, press
“Select” under the Select Control Module area.
Select “16-Steering Wheel” on the Control
Module Screen
The software is now connected to the new
MFSW control unit in the “Open Controller”
window. Note the Software Coding located
just below the part number display. Check
the chart on the next page to see what the
coding means. If the coding is satisfactory,
exit out of the VAG-COM software and skip
the remainder of this section. If the control
module needs to be recoded, continue with
the steps below.