Install guide

© 2005, 2006 Lee H. NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1 Page 17
-> Channel 070 (Display-Brightness)
0 – Switched off
1 - 20 % Brightness
2 - 40 % Brightness
3 - 60 % Brightness
4 - 80 % Brightness
5 - 100 % Brightness
-> Channel 099 (Transport Mode)
This channel is used only on vehicles without a CAN gateway.
0 – Transport mode inactive
1 – Transport mode active
-> Channel 111 (System Reset)
When you store a value of 1 the system is reset. The controller is restarted but fault codes are not cleared.
-> Channel 114 (FM-Sender Status)
On inquiry.
-> Channel 117 (Signal Position)
Adjustment of the signal output on individual speakers.
0 – Fader center – Balance Center
1 – Fader front – Balance left
2 - Fader front - Balance right
3 - Fader rear - Balance left
4 - Fader rear - Balance right
-> Channel 136 (Navigation references)
Adjustment of the voice prompts related to driver position.
00005 – Left hand drive (USA)
00013 – Right hand drive (USA)
02632 – Right hand drive (Europe)
03226 – Left hand drive (Europe)
Exit out of the Adaptation screen when
complete. Now is a good time to check out
the Measuring Blocks. These show
information on the active functions of the
RNS-E. From the Open Controller screen,
press “Meas. Blocks - 08”
The Measuring Blocks screen shows
different groups of values that display real
time readings. This is helpful because it
displays all sorts of information that gives
insight into the workings of the RNS-E.
Scroll through the groups to display
different information items.
Exit back out to the Main VAG-COM
screen when finished.