Install guide

© 2005, 2006 Lee H. NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1 Page 12
1.4 Control Module Coding (VAG-COM)
The RNS-E and instrument cluster must be coded with VAG-COM to ensure proper operation.
Connect a diagnostic cable to the vehicle and start the VAG-COM software on the computer.
In leiu of using VAG-COM software, the vehicle can be coded at any Audi dealership. Expect to pay for this service.
VAG-COM Release 512 is recommended.
From the Main VAG-COM screen, press
“Select” under the Select Control Module area.
Select “37-Navigation” or “56-Radio” on the
Control Module Screen. Either option will
access the RNS-E for coding.
The software is now connected to the RNS-E
in the “Open Controller” window. Note the
Software Coding located just below the part
number display. Check the chart on the next
page to see what the coding means. If the
coding is satisfactory, exit out of the VAG-
COM software and skip the recoding
instructions directly to the adaptation
settings. If the control module needs to be
recoded, continue with the steps below.
My coding is 0509635, this is for: A6 with Bose, SAT radio, BT module, and Multifunction Steering Wheel.