Install guide

© 2005, 2006 Lee H. NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1 Page 9
Plug-and-Play Harness wiring chart for Symphony I to RNS-E
Description
RNS-E harness end
Vehicle harness end
Pin A: Speaker Connecter Pin# Connector Description
1 N.C. N.C.
Connector 2 Right Front (+) 3 II RF+
not 3 Left Front (+) 5 II LF+
necessary 4 N.C. N.C.
for 5 N.C. N.C.
BOSE 6 Right Front (-) 4 II RF-
systems 7 Left Front (-) 6 II LF-
8 N.C. N.C.
B. EXT Control Connector
MOST network 1 Most Ring break N.C.
CDC Audio 2 CDC-NF GND 18 I S GND
Speed signal 3
V-Signal
1 III GALA
Battery Power out 4 U14R-2 16 I +12V
K diagnostic 5
K-Line
3 III K
CDC Data 6 CDC-Data out 14 I DATA OUT
Bose ground wire 7 BOSE Pin Ground for Bose Systems Only
CDC Audio 8 CDC-NF L.IN 19 I L CH
CDC Audio 9 CDC-NF R. IN 20 I R CH
accessory power 10 U14 ST CDC 17 I ACC
CDC Data 11 CDC -Data IN 13 I DATA IN
CDC Data 12 CDC- Data CLK 15 I DATA CLK
C: EXT Control Connector
mic for speech control 1 MIC IN (-) N.C.
reverse +12V 2 RFSL Connect to Reverse Wire
to amp 3 Line Out FL 4 I LF
mic out to tel module 4 MIC Out (-) N.C.
to amp 5 Line Out RL 1 I LR
tel module audio in 6 TEL NF IN (-) 4 IV TEL -
mic for speech control 7 MIC IN (+) N.C.
to amp 8 Line Out GND 3 I COM
to amp 9 Line Out FR 5 I RF
mic out to tel module 10 MIC Out (+) N.C.
to amp 11 Line Out RR 2 I RR
tel module audio in 12 TEL NF IN (+) 3 IV TEL +
CDC chassis ground Connect to Ground in convenient location 10 IV CD GND
D: Power Connector
infotainment bus 9
CAN-H
7 I CAN H
infotainment bus 10
CAN-L
12 I CAN L
Tel Module mute 11 TEL-Mute 1 IV MUTE
Main Ground 12 Kl.31 8 III (-)
Amp turn on 13 U14 ST DSP 6 I ACC
Alarm GND 14 DWA-GND
Connect to large brown single
pin connector
Main Power 15 Kl.30 7 III (+)
Battery Power out 16 U14R-1 N.C.
Legend
N.C. No Connection
NF Niederfrequenz English: Audio Frequency
Kl. Klemme English: Terminal
DWA Diebstahl Warnanlage English: Theft Alarm System