Specifications

NOTE: Before ensambling the monitor again, we recommend to cut down the outside plastic frame where the

touch panel has to be holded (see the images below).

Connect the Touch Panel cable to the touch screen, the other side to the ”TO TOUCH” INPUT of the SUB BOARD

module, and then you will be able to assemble again the screen on its original position.

The next step will be the image bridge between the SUB BOARD module and the HSD connection behind of the

radio. Disconnect the Purple Original LCD cable HSD

of the radio and connect it to the SUB BOARD module “TO

MONITOR” connection port. The “TO SYS” cable must be connected to the connector that we leaved free

previously (see it on the image).