Operation Manual

Navigation (NAV) 137
General operation RADIO, CD NAME, TEL NAV, INFO CAR, SETUP
Tips
Administration of the directory data is handled through the
button
Þ page 98.
Save route
Once calculated, route plans can be saved with the
route criteria you entered and loaded later as a new
destination.
Fig. 144 Navigation: Route plan
– Enter a route plan Þ fig. 144.
–Press the Memory control button in the navigation menu.
–Select Save route.
– Using the speller, enter the name for the route.
– Select OK in the speller. The route plan entered is saved.
A route plan provides the option of setting up to three stopovers in
addition to a destination
Þ page 121. You can then drive to each of
these destinations in turn in the sequence set up.
The route entered will be saved with the final destination and stop-
overs and can be loaded again as a new destination
Þ page 137.
The route plan can be changed at any time after input is complete.
Select a destination from the route plan by rotating and pressing
the control knob. Then you can select Change, Move, Delete or Drive
to now
Þ page 137.
If you have selected the Drive to now function and you would not
like to edit the route, route guidance is imported and current vehicle
location is used as the route guidance starting point after you have
selected Start route guidance.
If the Save route function is greyed out, this indicates that either the
route memory is full or the Route without stopover function (single
destination mode) is set. Please delete routes not needed from the
route memory
Þ page 138. Or select the Route with stopover func-
tion
Þ page 139
Tips
You can save individual destinations to the directory Þ page 135.
Load route
–Press the Memory control button in the navigation menu.
NAME