User's Manual

Fuses and bulbs288
Installing bulb carrier
The bulb carrier is easy to install.
– Insert the bulb carrier into the rear light. Make sure you
hear the retaining tab ⇒ fig. 281 click into place.
– Position the retaining clip so that the guide pins
are located in the recess on the retaining clip, and
tighten the nut .
– Fit the cover back in the interior trim so that it engages.
– Put the screwdriver back into the tool kit.
– Make sure that all bulbs for the rear lights are working.
Number plate light
Removing number plate light
– Take the screwdriver out of the vehicle tool kit
⇒ page 255.
– Insert the flat-blade side of the reversible screwdriver
insert into the slot on the number plate light ⇒ fig. 282.
– Using the screwdriver, start by pressing the number
plate light to the right -arrow 1- and then pull the number
plate light downwards from this position -arrow 2- and
out of the opening.
– Detach the number plate light.
Fig. 281 The retaining
clip for the bulb carrier
has a guide pin
A
A
A
B
A
C
A
D
Fig. 282 Boot lid:
Removing number
plate light
Fig. 283 Number plate
light: Retaining
element
document_0900452a8179700c.book Seite 288 Donnerstag, 22. März 2007 10:19 10