User's Manual

Fuses and bulbs282
– Press the connector in the direction of the arrow
⇒ page 281, fig. 267 until the bulb engages.
– Check that the bulb is securely seated in the bulb
housing.
– Fit the cover and swivel the retaining clip downwards.
– Install the headlight ⇒ page 278.
– Check whether the new bulb is working.
– Have the headlight settings checked.
Applies to vehicles: with xenon headlight bulbs
Changing bulb for turn signals
The bulb is secured in the bulb carrier with a bayonet
fastener.
– Remove the headlight ⇒ page 278.
– Take off the rubber cap (small cover) and remove the bulb
carrier.
– Lightly press the defective bulb into the bulb carrier, then
turn it anti-clockwise and remove it.
– Do not touch the glass part of the new bulb with your
bare hands, use a cloth or paper towel instead.
– Fit the new bulb, pressing it into the bulb carrier, and turn
it clockwise as far as it will go.
– If necessary, use a cloth to remove any fingerprints from
the glass part of the bulb.
– Insert the bulb carrier into the headlight.
Note
Ensure that the rubber cap is seated correctly so that no water can
enter the unit.
Applies to vehicles: with halogen dipped headlights
Changing bulb for side lights
Removing bulb for side lights
– Remove the headlight ⇒ page 278.
– Swivel the retaining clip of the cover upwards.
– Take off the cover ⇒ page 280, fig. 264 ⇒ page 280 ⇒
in “Changing bulbs” on page 276.
– Grasp the bulb holder by the handle ⇒ fig. 268 and pull it
out.
– Lightly press the defective bulb into the bulb carrier, then
turn it anti-clockwise and remove it.
Installing bulb for side lights
– Fit the new bulb, pressing it into the bulb holder and turn
it clockwise as far as it will go.
Fig. 268 Bulb holder
for side lights is high-
lighted
document_0900452a8179700c.book Seite 282 Donnerstag, 22. März 2007 10:19 10