User's Manual

Fuses and bulbs278

Bulb holders with a bayonet fastener

In the case of bulb holders with a bayonet fastener please

proceed as follows:

Removing the bulb holder

– Turn the bulb holder in the direction of the arrow

⇒ fig. 257 as far as it will go and then take the bulb

holder out of the light unit.

Fitting the bulb holder

– Insert the bulb holder into the light unit, making sure you

keep the bulb holder straight, i.e. the rubber seal makes

even contact all around.

– Turn the bulb holder in the direction indicated by the

arrow ⇒ fig. 257 as far as it will go.

Changing bulbs for headlights

Removing and installing headlights

The description for removing the headlight refers to the left

headlight; in principle the same procedure applies to the

right headlight.

Removing

– Switch off the ignition and the lights.

– Open the bonnet.

Fig. 257 Diagram: Bulb

holder with a bayonet

fastener

Fig. 258 Trim panel:

Attachment points are

marked by arrows

Fig. 259 Headlight

unit: Attachment

points are marked by

arrows

document_0900452a8179700c.book Seite 278 Donnerstag, 22. März 2007 10:19 10