Technical data

27
The 4 spacers on the front axle are
25 mm thick.
The spacers on the rear axle are of
different thicknesses. On the front
mountings; 23.5 mm, on the rear
mountings; 25 mm.
241_018
As a result of the spacers, longer
screws are used to attach the sub-
frame.
The spacers are eccentric.
There are two different thicknesses:
Thickness 25 mm and 23.5 mm.
The assembly instructions in the
workshop manual must be observed.
Spacers
Spacer
The front section of the propshaft has been
shortened in combination with the additional
shift stage.
As the body has been raised with respect to
the running gear (25 mm), practically all lines
and hoses leading to the drive train and to the
running gear (e.g., brake hoses) have been
modified.
The front drive shafts have been adapted in
length to the running gear kinematics. The
inside joint is a tripod constant velocity joint,
designed as a monoblock (formed sheet
metal housing).
For info. on the tripod constant velocity joint,
see SSP 192, from Page 40 on.
The rear drive shafts have increased
diameters and the external joints have been
strengthened.
The centre support of the propshaft has been
adapted to accommodate the raised body.
Drive train