User Guide

CONTROLS AND EQUIPMENT
58
– Driving time
Driving time elapsed will remain in
storage, even after the ignition is turned
off. Further driving time will be added
automatically after engine restart.
Maximum storage and display range is
23 hours and 59 minutes. To keep track
of driving time between points, depress
"Reset" for two seconds for zero.
Driving time alert
While driving, the computer will
automatically switch to the "driving time"
display every two hours. The indicator
"2:00" (or "4:00", "6:00", ''8:00" etc.) will
blink in the display window to alert the
driver to take a break. The blinker can be
turned off by briefly pushing "Reset" or
either side of the switch.
If the ignition is off more than ten
minutes, the driving time alert counter will
automatically start again from zero. If the
ignition is off less than ten minutes, the
display will blink again every two hours.
– Average fuel
consumption
The display will show the computed
average fuel consumption since the fast
"Reset'" and not the instantaneous fuel
consumption. When the ignition is turned
off, the computed average remains in
storage. When driving is resumed, the
averaging computation continues
automatically. To delete stored data,
push "Reset". The display will show "0.0"
for about 100 feet or 30 meters.
– Average driving
speed
The display will show the computed
average of driving speed variations since
the last "Reset". When the ignition is
turned off, the computed average
remains in storage. When driving is
resumed, the averaging computation
continues automatically. To delete the
stored data, push "Reset".