User Guide

CONTROLS AND EQUIPMENT
25
Memory switch controls
For the driver’s convenience, an electric
control panel for storage of 4 different
seat positions has been installed in the
door panel.
ON-OFF switch
During storage and recall, the switch
must be pressed in the "ON" position.
In case of a malfunction, switch the
memory system off by pressing the
switch to the "OFF" position. Have
your Audi dealer locate and correct the
problem. Until then, use switches on
outboard side of seat only.
To store seat position in memory
Adjust seat with controls on outboard
side of seat. Depress and hold memory
bar and depress one of the 4 buttons to
store the desired position. Each
successive storage under the same
button cancels the previous one.
To recall seat position from memory
With door open or within approximately
30 seconds after closing door, briefly
push the desired recall button. The seat
will adjust automatically to the stored
position.
With doors closed, hold recall button
depressed until seat has reached the
stored position.
WARNING
Do not recall seat position from
memory while the vehicle is in motion.
Electrically heated seats
*
With ignition on the backrests and seat
cushions of the front seats and the left
and right seating position of the rear seat
bench* can be heated electrically. See
page 59 for details.
*
where applicable