User's Manual

Note: The headset is connected to a mobile phone or other
electronic devices using radio frequency signals which cannot
guarantee connection under all conditions or circumstances.
Therefore, please never rely solely upon the headset for essential
or emergency communications.
8. RF frequency and energy may affect some electronic systems
in a motor vehicle. Please check with the manufacturer to
ensure that the headset will not affect the electronic systems
in the motor vehicle.
9. Some medical electronic equipment may not be shielded
from RF energy. Therefore, please do not use the headset
near medical equipment without permission.
10.Please turn off the headset before boarding any aircraft.
To prevent any interference with communication systems,
please do not use the headset while the plane is in the air.
11.Please turn off the headset in any area with a potentially
explosive atmosphere.
12.Please do not allow children to play with the headset since
it contains small parts.
21
Important information
Changes or modifications to this unit not expressly approved by
the party responsible for compliance will void the user's authority
to operate the equipment. Any change to the equipment will
void FCC grant.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different
22
Warning