User Manual

BMP42 - User manual08

Chapter 2

Overview BMP42

The BMP42 is a SourceCon™ compatible module featuring an (internal) board-edge connector which carries all signals for

getting it connected to any supporting main unit.

All external in & output connections shall be made using the available connectors on the panel.

1) Balanced stereo line output:

The balanced stereo line output is implemented using two 3-pin terminal block connectors. The audio output available on

this connector allows it to be fed to any amplier or pre-amplier.

2) SMA-type antenna connection:

The antenna (input) connection is implemented using an SMA-type (male) connector whereto the supplied antenna should

get connected. Depending of the installation conditions (e.g. when installed in a closed / shielded cabinet), it can be extended

using optional available accessories for optimal reception conditions.

3) Connection external pairing contacts:

When the BMP42 is installed in a device located in something

like a locked rack, it may be difcult to enable Bluetooth pairing

for new devices. For this purpose, an external pairing connector

can be connected that contains the combination LED and button.

When the button is pressed, Bluetooth pairing is enabled. This is

conrmed by the ashing of the LED.

If a device was connected, the connection is broken. The LED will

icker for 60 seconds and the BMP42 is visible to make a (new)

connection. If a device connects, the LED will remain lit. After 60

seconds without connection, the BMP42 is no longer visible to

new devices but old devices can still connect. After 60 seconds

the LED will be off.

The connection can be made according to this wiring diagram:

Button