User's Manual

10
Antenna Installation
Align the antenna with the
connector on the top of the radio,
and screw it in clockwise until it is
tightened.
Note:
Do not hold the radio
by its antenna; otherwise, the
performance and service life of
radio may be a󰀨ected.
Belt Clip Installation
Accessory Installation
Step 1:
Remove the belt clip
screws from the device.
Step 2:
Align the radio screw
holes on the belt clip, and then
tighten the screws.
Step 1:
Open the accessory
connector cover.
Step 2:
Align the plug of the
accessory (matching headset
or programming cable) with the
accessory connector.
Step 3:
Insert the accessory
properly into the accessory
connector.