User`s guide

M1 System Management Board User’s Guide 39
4
Setting Thresholds
This section details how to set the thresholds used throughout the demonstration. The board thresholds can be set in
two different ways in the Thresholds tab: you can set and see the points and triggers graphically or you can use the high-
water/low-water slider marker, which will allow tracking of extreme values.
Setting the Thresholds Graphically
1. Click the Graphs tab.
2. Slide the marker on the right hand side of the graph to set the maximum/minimum and local maximum/minimum
levels. To change these, simply drag the arrow to the desired position.
3. Click Zoom Fit to fit the graph in the window. The red/yellow line across the graph represents the level marker (red
represents the absolute maximum/minimum or Hi-Limit/Lo-Limit; yellow represents the local maximum/
minimum or Hi-Warn, Lo-Warn).
Note: The maximum/minimum and local maximum/minimum lines are better viewed in a white background.
Figure 4-1. Setting Thresholds Graphically