User`s guide

Comms
M1 System Management Board User’s Guide 35
(see “Thresholds” on page 36). The timestamp is based on the time set on the board at the instant the event occurred.
The events show all crossing of thresholds (including returning to normal). See “Event Log Tab” on page 35.
Figure 3-4. Event Log Tab
To upload the stored event log from the target board, click the Update button. Refer to “To set up sample/threshold data
logging:” on page 46 for more information about setting up event logging.
Comms
The Comms tab allows you to change the baud rate, the COM port in use, and start or stop reception and transmission
of bit sequences as part of the System Management software.
The following options are available from the Comms tab:
• Start Rx: Starts reception of data
• Start Tx: Starts transmission of data
• Stop Rx: Stops reception of data
• Stop Tx: Stops transmission of data
• Bytes Tx: Bytes transmitted
• Bytes Rx: Bytes received
• Enable GUI Test: Check this box for debugging purposes if problems arise with the demonstration