User`s guide

Board Status
M1 System Management Board User’s Guide 33
Controls
To display the state (open or closed) of the on-board DIP switches, open and close the DIP switches on the board. The
results are displayed in the software.
To display the potential difference across the potentiometer, adjust the rotating switches on the board. The results are
displayed in the software.
Board Supply
The board supply displays a real-time reading of the voltage and current ratings for the main supply. It also displays the
real-time voltages for the 1.5 V, 3.3 V, and 5.0 V supplies respectively. See “Voltage, Current and Temperature Status
Indicators” for more information on the status indicators.
PSU Supply (ATX Supply)
The PSU supply displays the real-time voltage and current ratings for the attached ATX (3.3 V, 5.0 V, and +12 V)
supply, and the real-time voltage for the -12 V supply.
Temperature
The temperature section displays the real-time temperature (°C) on the board from the sensors loaded at the heater, the
PCI, the finger pad, the regulator, and the board itself.
Voltage, Current and Temperature Status Indicators
The following explains the voltage, current, and temperature status indicators found in the Board Status tab next to each
reading.
Red - Voltage/current/temperature is above the maximum or below the minimum.
Green - Voltage/current/temperature is within set range.
Yellow - Voltage/current/temperature between maximum and local maximum or between minimum and local
minimum.