User`s guide

System Management Software
32 M1 System Management Board User’s Guide
Board Status
The Board Status tab is split into ten panels that control the behavior of the board (Figure 3-2).
Figure 3-2. Board Status Tab
LEDs
To turn on and off each LED on the board, click the corresponding LED button in the software.
LCD
To output two lines of text to the LCD screen, type the text that you want to display and click the Set to button. The
board firmware also uses the LCD and displays the “Clock”.
Clock
To synchronize the real-time on-board clock with the computer’s local time, click the Set From PC button.
Push Buttons
To test the correct synchronization between the push buttons on the board and the software, push the button on the
board and check that the corresponding button in the software lights up.
Demonstration
In this version only basic operations are demonstrated. However, in future versions you will be able to select from a range
of pre-selected demonstration scripts.
Internal Flash Memory
Enter the starting address (in hexadecimal) and click the Update button to dump all current data and the addresses
stored in the internal Fusion nonvolatile Flash memory into this window for debug purposes. Commencing at the
starting address, the data lists each byte chunk on each line, 16 in total, ending in their corresponding ASCII code. 16
lines are printed, representing 256 bytes of nonvolatile memory.