Specifications

Step 3. Slide each clip so they come in contact with the top edge of the add-on cards.
While holding the clip firmly against the card edge, tighten the bracket screws.
Step 4. Cut off any excessive part of the plastic clip.
Step 5. Repeat these steps for the other stabilizer.
Slant the add-on card stabilizer and put it
in the case, then set straight and fix it.
Use screw #7 to secure it.
Use the screw removed earlier. Insert it into
the threaded hole and tighten it.
Press the plastic extender firmly against the
card edge and tighten screw.
Cut off any excessive part of the plastic clip.
Preparing to Start the System
Connecting the Video and Input Devices
The location of your video output, keyboard and pointing device connectors are board
dependent. Connect the video cable to the VGA output connector on your SBC or other graph-
ics card. Connect the keyboard and pointing device connectors to their sockets and firmly push
them into the sockets.