Specifications

find the mount point of the backplane
insert the stand offs
Thread clock-wise to insert the standoff
reverse to take off the stand off
Your package comes with metal standoffs threaded on one end and tapped on the opposite
end to receive a mounting screw.
Step 3. Now carefully withdraw the backplane and thread the standoffs into the mounting
holes in the chassis.
Step 4. Align the mounting pointing points and insert the screws into the metal standoffs.
Step 5. Tighten the screws. (add washer if the screws will short with the circuit of the
backplane)
Slant the backplane and lower the
backplane into the chassis
Turn clockwise to secure the screws
you may insert the insulating washer between
the screw and backplane to avoid
the shorting