User's Manual

Stinger S650

Radar detector

4. Bend the angle of the windshield mounting bracket, if necessary, to adjust

for best viewing and detection angle.

5. When you want to connect power from your vehicle, plug the small

connector of the power cord into the 12-volt DC power input jack located on

the side of the detector.

6. Plug the large adapter of the power cord into the lighter socket of your

vehicle.

Hook-and-Loop Mounting

The hook-and-loop tape included with your detector might be the best

mounting method for some dashboards. Follow these instructions to use the

hook-and-loop tape.

1. Use a damp cloth to thoroughly clean both the bottom of the detector and

the dashboard.

2. Peel off the tape's paper backing and apply the tape to the bottom of the

detector.

3. Remove the paper backing from the other side of the tape and press the

detector onto the dashboard.

Changing the Panel

To change the panel to another one, follow these steps.

1. Lift up the panel by forefinger or screwdriver from the slot at the mounting

bracket location. The panel will pop out as follows.

2. Insert the tap of replacing panel near the display into the unit. Gently snap

in the other taps to the back of the unit.